Cut Size Polished Edge Toughened Glass
First, the tempered glass processing process Cutting - edging - cleaning - tempering - homogenization Second, the essentials of the process of tempered glass processing 1, glass cutting Machine cutting glass a start glass cutting machine (including computer and printer) b Input the original film...
First, the tempered glass processing process
Cutting - edging - cleaning - tempering - homogenization
Second, the essentials of the process of tempered glass processing
1, glass cutting
Machine cutting glass
a start glass cutting machine (including computer and printer)
b Input the original film specifications and the number of cuts and specifications into the computer. The computer automatically compiles the puzzle and calculates the number and utilization of the original film.
c Print the puzzle results and transfer them to the glass cutter.
d Load the original glass on the machine cutting table and position it as required.
eSelect and run the cutting program to cut the glass.
f Separate the cut pieces and store them on the designated rack.
a start glass edging machine
bAdjust the machine parameters, ie the amount of grinding, the width of the belt, the conveying speed and the pressure value of each polishing wheel when polishing is required.
c Trial grinding: Test the grinding with a glass of the same type and thickness as the glass to be ground, check whether the grinding amount, chamfering and edging quality meet the requirements, do not meet the requirements, re-adjust until satisfactory, confirm the parameters .
d Load glass edging.
e Check the quality of the edging and adjust the machine parameters appropriately.
f Grind the edged glass, move it to the designated glass frame, and label it.
a glass washer before use to check whether the water is sufficient.
b Start the washing machine (including the water treatment system) and put the machine in automatic operation.
c Load glass cleaning, check the cleaning effect, if not required, adjust the water temperature, washing speed and transmission speed until qualified。
d Load the glass in the specified order, and clean it automatically。
e When the cleaned glass is stacked, the blocks are separated from the blocks by paper, and the various specifications are separated and marked to avoid damage and confusion。
a Check whether the cleaned glass meets the requirements。 Any glass with defects such as sand and scratches cannot be tempered。
b Adjust the parameters of the tempering furnace according to the drawing requirements of the deep-processed glass.
c First take two pieces of the same thickness of the same type of glass for tempering, check whether the tempering effect meets the requirements.
d loading glass tempered.
The tempered glass shall be carefully inspected and the qualified products shall be transported to the designated glass frame。
5, homogenization treatment
The tempered glass that needs to be homogenized according to the drawings must be homogenized in the detonating furnace and then transported to the semi-finished area for transfer to the next process。